Filter
Top Products
Appendix C Customizing the printer
October 1997 C-3
5. If the printer’s other SCSI port is not in use, connect a 50–pin SCSI
terminator to that port.
6.
If the hard drive does not have an internal terminator
, connect a
terminator to the open SCSI port.
Refer to the manual shipped with the hard drive for instructions.
7. Turn the hard drive and then turn the printer on.
Initializing the hard drive
Next, you must initialize the hard drive.
These directions tell how to initialize a drive with the printer connected to
a Macintosh computer.
WARNING: Initializing the drive reformats it, and all data on the
drive will be lost. Complete this procedure only as
part of the installation process.
1. To set up the printer to communicate with an external hard drive, you
must first enable the initiator.
- Press
Select/Setup
on the display panel to enter the Setup menu.
- Select:
“Ports”
“SCSI Initiator:Enable”
- Set to YES*.
- Use the Select/Setup key to exit the menu.
2. Open the Chooser. Using the Laserwriter 7.x driver, select the
8650 PS Printer to which the hard drive is connected.
3. If you did not install the utilities program when you loaded the
drivers, insert the CD shipped with the printer into the CD-ROM
drive.
The icon for the CD appears.
4. Double-click on the icon for the CD.
5. Double-click on the English folder.
6. Double-click on the Utilities folder.