Filter
Top Products
Appendix C Customizing the printer
October 1997 C-13
Finishing up
To finish up the installation:
1. Grasp the black handles on the back of the printer and slide the
drawer in about three inches.
2. Reconnect the ribbon cable by pressing it firmly into the connector.
3. Make sure that the plastic clips on each side of the ribbon cable
are latched.
4. Close the drawer the rest of the way.
5. Replace the five screws that you removed.
6. Plug in the printer and turn it
On
.
7. Verify that the Power light is lit on the display panel.