Filter
Top Products
A-61070 September 1999 6-5
Code Message Displayed Description/Action Required
E139 Confirm tone - not mach
enabled
Tried to use a confirmation tone function code (F53,
F63, F75) but the confirmation tone is not enabled. If
a confirmation tone is required, contact your system
administrator.
E150 Buffer data transfer to host Tried to change function codes via F02. Cannot
perform this function while scanned images are in
the image buffer. After pressing C, enter F02 again
when all images have been read by the host.
E151 Buffer data transfer to host Tried to use the bar code test via function code F65.
Cannot perform this function while scanned images
are in the image buffer. After pressing C, enter F65
again when all images have been read by the host.
E152 Scanning - try again Tried to enter a function code while scanning. Press
Stop/End to stop scanning.
E204 Re-scan - skew monitor err Tried to scan a document that is skewed greater
than the maximum skew angle and less than 30
degrees. Note the document that was skewed and
press C.
E205 IA Overflow - press Next key One of the image address fields has been
overflowed. For example, if the Level 1 field is set for
two digits, up to 99 Level 1 documents can be
scanned, the 100
th
document will cause an overflow.
Press Next or one of the Level keys to change the
image address or level so the corresponding field
does not overflow.
E207 Printer hardware error At power on, a Document Printer hardware error has
been detected. Press C to clear message and
contact Service.
E208 Bar Code hardware error At power on, a Bar Code hardware error has been
detected. Press C to clear message and contact
Service.
E209 Bar Code data overflow Bar Code Reader detected more than the maximum
80 characters. Verify the bar code has more than 80
characters. Disable the Bar Code Reader (F64) and
rescan the document.
E214 Rescan - length monitr err Tried to scan a document that was shorter or longer
than the maximum or minimum length set up for the
application mode or possibly a multi-feed condition.
Check the document and rescan the document.
E216 Printer hardware error At power on, a Document Printer hardware error has
been detected. Disable the Document Printer (F40-
F42) or select an application mode that does not use
the Document Printer.