Filter
Top Products
|
Konica FAX 993014
Auto Tray Switch
User Function 80
Settings are: ON or OFF
Default is: OFF.
When Auto Tray Switch is set to ON, your fax machine will
use paper from another tray when paper runs out in one tray.
!
The optional second tray must be installed for this to
function.
The same size paper must be installed in both trays.
Paper Size Check
User Function 81
Settings are: ON or OFF
Default is: ON.
Set to ON
If Paper Size Check is set to ON, an alarm displays when
the paper size specified from the PC does not match the
paper size specified for the tray of the fax machine.
When this alarm is displayed, put the correct size of paper
in the specified tray. Printing begins when the tray is
closed.
After printing,
• set the same paper as configured for the tray
or
• change the tray configuration to the correct paper
size.
Set to OFF
If Paper Size Check is set to OFF, printing occurs even if
the PC-specified and Paper Tray paper sizes don’t match.
LAN Print T.O.
User Function 82
It is impossible to judge whether printing data is not being
transmitted due to network delay or the end of the data
stream. This time-out configuration allows the device to
cancel a print job when no printing data can be found after
a specified time has elapsed since the last data was
submitted.
Do not change the default configuration unless it is
absolutely necessary.
Settings are: 5 sec., 30 sec., 5 min.
Default Setting is: 30 sec.