Filter
Top Products
|
T.37Internet FAX User’s Guide 21
DHCP Server
If you are working with a DHCP (Dynamic Host
Configuration Protocol) server, the following items are set
automatically.
1: IP ADDRESS
2: SUBNETMASK
3: DEFAULT GATEWAY
8: DNS P .SRV ADDRESS
Domain Name Service Primary Server
9: DNS S .SRV ADDRESS
Domain Name Service Secondary Server
!
Use permanent IP addresses from DHCP.
After changing the network settings under User
Function 93, press MENU.
The machine goes into standby mode.
After a few seconds’ pause, the display shows that the
Network Card is being initialized. The data on the
Network Card is updated when this message disappears.
Do not press MENU again while the initialization
message is on display (after changing the settings);
if you do, the settings will not update correctly.
Explanation of Settings
1: IP ADDRESS
Sets the IP address.
2: SUBNETMASK
Sets the subnet mask.
3: DEFAULT GATEWAY
Sets the default gateway address.
4: SMTP SERVER NAME
Enter either the IP address or the host name of the SMTP mail server.
!
If the DNS name of the SMTP server does not work,
try entering the IP address of the SMTP server.
Restrictions
••
••
• If DNS has been set, use the host name (e.g., mail.network.com).
••
••
• If DNS has not been set, enter the IP address of the server. The
address must include the “.” (period) dividers (e.g.,
192.168.4.123).
••
••
• up to 64 characters may be entered.
You may use Latin letters, numbers and symbols
To enter symbols, use either one-touch key 20 or key “0” of the
numeric ten-key pad.
The symbols that can be used are: ! # & ’ ( ) * + , - . / : ; = ? · @ ?
” _ % ~
The “~” (tilde) symbol shows on the display as “
-1
”.
Both uppercase and lowercase letters can be used. To change the
case, press the CAPS key (one-touch key 31).