Filter
Top Products
|
Konica FAX 993046
Windows NT 4.0 and Windows 2000
Recommended procedure:
1 Install the printer driver.
3 Configure the network card.
When printing directly from Windows NT 4.0 or 2000, use LPR
(Microsoft TCP/IP Printing), included in Windows NT 4.0 and
2000.
Add the LPR port as the driver output port and assign it the
IP Address configured for Network Card.
TCP/IP should be added to Windows NT 4.0, 2000 because it
is used for LPR.
!
While installing the driver on Windows 2000, you may
encounter a warning message about authentication.
Ignore this message if it appears.
It will not cause any problems with the installation of
the driver.
For more details, see the information on the supplied CD-ROM.
Windows 95/98
Recommended procedure:
1 Install the printer driver.
3 Install the Konica Print Monitor (LPR Utility).
4 Configure the network card.
When printing directly from Windows 95/98, the Konica
print Monitor (LPR Utility) should be installed from the
supplied CD-ROM.
TCP/IP must be installed in Windows 95/98 in order to use
Konica Print Monitor (LPR Utility).
For more details, see the information on the supplied CD-ROM.
Windows 3.1
Recommended procedure:
1 Install the printer driver.
2 Run SETUP.EXE from the Win31 directory on the
supplied CD-ROM.
3 Configure the network card.
When printing from Windows 3.1, a NetWare Server is required,
since Windows 3.1 is not a network operating system.
Printing via LPR, from Windows 3.1 connected to the network
with other commercial TCP/IP protocols, is not assured.