Filter
Top Products
7
Using the Utility Mode
7-8 Konica 7115/7118
Erase Setting (Left, Upper, and Frame)
Set the erase width for each of the Left, Upper, and Frame Erase copies in the range between
1/4 and 3/4 (in 1-mm (1/16) increments).
●
The default value is “1/2” for Left, Upper, and Frame Erase.
Auto Panel Reset
Select the time it takes the auto panel reset function to be activated, from among “30 seconds,”
“1 min,” “2 min,” “3 min,” “4 min,” or “5 min,” or not activated at all.
●
The default value is “1 min.”
Power Saver
Set the time it takes the copier to enter the Power Saver mode, from 1 min to 240 min (in 1-min
increments).
●
The default value is “15 min.”
Auto Shut-OFF
Set the time it takes the Auto Shut-OFF function to be activated, from 15 min to 240 min (in 1-
min increments). To disable the Auto Shut-OFF function, first “authorize” the “Disable Auto Shut
OFF” under the Administrator Mode (p.7-26) before selecting “Auto Shut-OFF disabled.”
●
The default value is “30 min.”
Density (ADF)
Adjust the copy image density level when the copier is equipped with an Automatic Document
Feeder.
Mode 1: Used for the standard original, such as a typed document.
Mode 2: Effective in reproducing a pale original, such as a faint pencil-written document.
●
The default value is “Mode 1.”
Printer Density
Select the image density level of copies and printed pages from among “-2,” “-1,” “0,” “1,” or “2.”
The smaller the value, the lighter the image, and the greater the value, the darker the image
with “0” as the center value.
●
The default value is “0.”
Konica7115_7118.book Page 8 Friday, October 19, 2001 12:02 PM