Filter
Top Products
3
Before Making Copies
3-18 Konica 7115/7118
Power Saver
Instead of turning the copier OFF, it can be set to standby mode (Power Saver mode).
To set the copier into the Power Saver mode, press the [POWER SAVE] key. In addition, if the
copier is not used for a set length of time, it will automatically enter the Power Saver mode. The
default length of time is 15 min.
To cancel the Power Saver mode, press any key on the control panel.
✎
Note
If the Auto Shut-OFF function is activated while the copier is in the Power Saver mode, the
copier will automatically turn itself OFF.
✎
Tip
The length of time before the copier enters the Power Saver mode can be set between 1
min and 240 min.
For more details, refer to “User’s Choice” (p.7-2, p.7-8).
Auto Shut-OFF
If a set length of time elapses after the copier has been used last, the copier is designed to
automatically turn itself OFF to save energy. The default length of time is 30 min.
✎
Tip
The length of time before the Auto Shut-OFF function is activated can be set between 15
min and 240 min. The Auto Shut-OFF function can also be disabled. For more details, refer
to “User’s Choice” (p.7-2, p.7-8 and p.7-26).
Auto Copy Start
If a document is loaded and the [START] key is pressed during the period after the copier has
been turned ON but before it is ready to make copies, the copier will automatically start the copy
cycle as soon as it completes the warm-up cycle.
Konica7115_7118.book Page 18 Friday, October 19, 2001 12:02 PM