Filter
Top Products
Troubleshooting Tips
9
Konica 7115/7118 9-1
9 Troubleshooting Tips
9.1 When This Type of Copy is Produced
Symptom Possible Cause Action
The image is too light. The image density is set at “Lighter.” Adjust the image density to the darker
side. (p.5-16)
The paper is damp. Change the paper. (p.8-4)
The image is too dark. The image density is set at “Darker.” Adjust the image density to the lighter
side. (p.5-16)
The original is not placed firmly
against the Platen Glass.
Place the original in position so that it
is placed firmly against the Platen
Glass. (p.4-7)
The copy is blurry. The paper is damp. Change the paper. (p.8-4)
The original is not placed firmly
against the Platen Glass.
Place the original in position so that it
is placed firmly against the Platen
Glass. (p.4-7)
The copy has lines.
The copy has dark specks or spots.
The Platen Glass surface is dirty. Wipe the Platen Glass clean with a
soft dry cloth. (p.10-5)
The Original Pad is dirty. Wipe the Original Pad clean with a soft
cloth dampened with neutral
detergent. (p.10-5)
The original is highly transparent. Place a blank sheet of paper over the
original. (p.4-8)
The original is 2-sided. The information on the backside of a
2-sided, thin original may be slightly
reproduced on the copy. Adjust the
image density to the lighter side. (p.5-
16)
Konica7115_7118.book Page 1 Friday, October 19, 2001 12:02 PM