Filter
Top Products
Before Making Copies
3
Konica 7115/7118 3-15
3.5 Turning ON and OFF and the Initial Mode
How to Turn the Copier ON/OFF
Turning Copier ON:
➜
Press the Power Switch to the 1 (ON) position.
Turning Copier OFF:
➜
Press the Power Switch to the 2 (OFF) position.
✎
Note
Do not turn the copier OFF while a copy cycle is being run, as paper misfeed will result.
Before attempting to turn the copier OFF, always be sure that the current copy cycle has
been completed.
Turning the copier OFF will initialize all settings except those for the jobs previously
programmed and Utility Mode.
✎
Note
The copier automatically enters the Energy Saver mode 15 min after it has been touched
last. It enters the Auto Shut OFF mode automatically 30 min after it has been touched last.
The time for the copier to enter the Energy Saver and Auto Shut OFF mode can be set in
the User’s Choice mode. For details, refer to “Using the Utility Mode” (p.7-1, p.7-8).
When Copier is Turned ON
When the Power Switch is turned ON, the [START] key starts blinking indicating that the copier
is warming up.
At this time, the copier can be specified for the Auto Copy Start function by loading a document
in the Automatic Document Feeder and pressing the [START] key.
Pressing the [START] key at this time will not immediately start the copy cycle. Rather, you are
going to have to wait for about 30 seconds (at an ambient temperature of 73.4°F/23°C).
Konica7115_7118.book Page 15 Friday, October 19, 2001 12:02 PM