Filter
Top Products
230 IBM 9077 SP Switch Router: Get Connected to the SP Switch
5. The SP Switch Router Adapter card is connected to the SP Switch and
configured. Check with
SDRGetObjects switch_responds on the CWS and
use
Eunfence if needed.
The following tasks are performed on the respective SP nodes:
1. On the nodes in SP21, the following route needs to be set:
route add -net 192.168.13 -netmask 255.255.255.0 -mtu 65280 10.50.1.2
2. On the nodes in SP2, the following route needs to be set:
route add -net 192.168.14 -netmask 255.255.255.0 -mtu 65280 10.50.1.1
Hint
: You
must not
use SMIT to set the routes and put them into the ODM.
The SP Switch is not working when these routes are set, at boot time.
Therefore, they are put onto another, already available network interface, for
example the control Ethernet, and this is definitely not what you expect to
happen.
Use a separate /etc/rc.routes shell script that is run only after an
Estart or an
Eunfence was issued, or use some other mechanisms to have this route set
only after the css0 interfaces on the SP nodes are up and running.
Setup is done now, and every node in SP2 should now be able to
ping every
node in SP21 and vice versa.
3. Check for correct routing entries on all nodes in SP21:
4. Check for correct routing entries on all nodes in SP2:
root@sp21en0:/ dsh netstat -rn | grep 192.168.13
sp21n01: 192.168.13/24 192.168.14.4 UG 5 717959 css0 65280 -
sp21n05: 192.168.13/24 192.168.14.4 UG 2 172837 css0 65280 -
sp21n06: 192.168.13/24 192.168.14.4 UG 0 0 css0 65280 -
sp21n07: 192.168.13/24 192.168.14.4 UG 2 141374 css0 65280 -
sp21n08: 192.168.13/24 192.168.14.4 UG 0 0 css0 65280 -
sp21n09: 192.168.13/24 192.168.14.4 UG 2 78305 css0 65280 -
sp21n10: 192.168.13/24 192.168.14.4 UG 0 0 css0 65280 -
sp21n11: 192.168.13/24 192.168.14.4 UG 0 202459 css0 65280 -
sp21n13: 192.168.13/24 192.168.14.4 UG 5 543370 css0 65280 -
sp21n15: 192.168.13/24 192.168.14.4 UG 1 384799 css0 65280 -
root@sp21en0:/