Filter
Top Products
7-14 Lucent Technologies Inc.
USS-720 Preliminary User Guide, Rev. 2
USB Device Driver February 1999
13
4 I/O Control Codes (continued)
4.5 IOCTL_1284_ TERMINATE
IOCTL_1284_ TERMINATE performs a standard 1284 termination sequence. Details regarding parameters and
error codes follow.
4.5.1 Parameters
lpInBuffer—Points to an input buffer. Not used with this operation. Set to NULL.
nInBufferSize—Specifies the size (in bytes) of the buffer pointed to by lpInBuffer. Not used with this operation. Set
to zero.
lpOutBuffer—Points to an output buffer. Not used with this operation. Set to NULL.
nOutBufferSize—Specifies the size (in bytes) of the buffer pointed to by lpOutBuffer. Not used with this operation.
Set to zero.
lpBytesReturned—Points to a DWORD that receives the actual size (in bytes) of the data stored into lpOutBuffer.
Not used with this operation.
4.5.2 Notes
Requires that the register-based mode be successfully set to ECP_REGISTER_MODE or
ECP_RLE_REGISTER_MODE (see
USS-720 USB-to-
IEEE
1284 Bridge
Preliminary Data Sheet, “Register-Based
Operation” and Section 4.4, IOCTL_1284_SET_MODE, of this document).
4.5.3 Error Codes
ERROR_INVALID_ALTERNATESETTING—This command is only supported in ALT_INTERFACE_2 (see
Section 4.9).
STATUS_IO_DEVICE_ERROR—Standard termination failed.