Filter
Top Products
Application Note
June 1999
13
Lucent Technologies Inc. 9-1
Instructions for Downloading Software for Use
with the In-System Design USB Smart Cable
Introduction
Before you begin, please note: In order to use the
software for the In-System Design USB Smart Cable,
the PC where the software will be installed must be
running either:
■
Windows
* 95/version 4.00.95b with the USB sup-
plement (QFE 1214), also known as OSR2.1 or
■
Windows
98
No upgrade path is available from previous versions
of
Windows
95/version 4.00.950 to OSR2.1.
Windows
95/version 4.00.95b (OSR2.0) must first be
installed, and then the system can be upgraded to
OSR2.1. The USB supplement file, usbsupp.exe, is
required to upgrade the OSR2.0 operating system to
OSR 2.1 (QFE 1214). Contact
Microsoft
* to obtain
this file.
Software Installation Instructions
1. Point your web browser to
http://www.in-system.com to access the In-Sys-
tem Design web site.
2. Click on "Drivers".
3. For the library name, type: uss720_dev
Note: Use lower-case letters only.
4. For the password, type: usb_to_lpt
Note: Use lower-case letters only.
5. Click on "Enter Library".
6. At this point, the uss720_dev library page will
appear with a list of files.
7. If your PC is running OSR2.1 with QFE, click on
OSR21_USS720_Eval_Kit_2401.zip to down-
load the installation files. Continue to step #9
below.
8. If your PC is running
Windows
98, click on
W98_USS720_Eval_Kit_2402.zip to download
the installation files.
9. Unzip the above file and store the extracted files
either on a diskette or in a directory on your hard
drive. When you install the USB Smart Cable, you
will direct the operating system to search for the
files in the location you have selected.
*
Windows
and
Microsoft
are registered trademarks of Microsoft
Corporation.