Filter
Top Products
Quattro DC Drive Operation and Feature Overview
Status Indicator Lights
Five status indicator lamps are provided on the
front panel of the drive.
READY – (GRN) Power is applied to the drive,
there are no drive Faults and drive is
ready to Run when requested. The Run
light will blink slowly when it is in DSPR
(Drive Standby Power Reduction) Mode
or not boosting, but three-phase power is
applied.
RUN – (GRN) Indicates that the motor
contactor is closed and the drive is
following applied references operating to
control torque and speed
PROGRAM INVALID – (RED) There is no
valid program loaded.
FAULT – (Red) A drive Fault exists that is
preventing the drive from operating
CURRENT LIMIT – (YEL) Motor current is
being limited
MONITOR / Adjust / Set-up Parameters:
The values of all adjustments and set up
parameters are stored locally in non-volatile
drive memory. Monitoring of live data status
and modification of parameter values can be
accomplished by sequences over the serial
link or the Magnetek Operator. They can both
be attached at the same time to modify
parameters or monitor drive operation.
Detailed descriptions of all adjustments are
located in later sections of this manual.
READY
RUN
PROGRAM INVALID
FAULT
CURRENT LIMIT
25