Maxtor 10K V Computer Drive User Manual


 
Maxtor Atlas 10K V 5-43
5.12.8 Verify Error Recovery Page (07h)
The Verify Error Recovery Page controls the drive’s response to error conditions that
arise during the VERIFY command and during the verify operation of the WRITE
AND VERIFY command. The Verify Error Recovery Page is not supported in the
SCSI-1/CCS Operating Mode. The data format and field descriptions are described
in Table 5-64 and Table 5-65 respectively.
Table 5-64 Verify Error Recovery Page-(Page 7)
EMDP 0
Enable MODIFY DATA POINTER. Not supported by the drive.
Fairness
Arbitration
111b
(Def)
Indicates whether or not the target should use fair or unfair (e.g., priority) arbitra-
tion when beginning the interconnect tenancy.
000b
- Disables the fairness algorithm. A fixed priority scheme based on the SCSI
ID assigned is used.
Non-Zero - Any non-zero value enables the fairness algorithm (SCSI SPI-2 ANSI
standard, Appendix B).
DImm 0
Disconnect Immediate. When set to a 1, to reduce on-bus time, the drive is forced
to disconnect from the SCSI Bus after a SCSI Command is received. Disconnect
Immediate works only when a typical, error-free command is received. Disconnect
Immediate does not apply in exception conditions (for example, SDTR received,
error, etc.).
DTDC Data Transfer Disconnect Control. This field of three bits defines further restrictions when a discon-
nect is permitted. These are as follows:
Value Description
000b
(Def)
Data transfer disconnect control is not used. Disconnect is controlled by other
fields in this page.
001b
- A target will not attempt to disconnect once the data transfer of a command
has started until all data of the command has been transferred. The connect time
limit and bus inactivity limit are ignored during the transfer.
010b - Reserved
011b
- A target will not attempt to disconnect once the data transfer of a command
has started, until the command is complete. The connect time limit and bus inac-
tivity limit are ignored once the transfer has started.
First Burst Size 0
This field indicates the maximum amount of data that a target may transfer for a
command during the same interconnect in which it receives the command. Not ap-
plicable for parallel SCSI.
Bit
Byte
765 4 3210
0 PS Rsvd Page Code (07h)
1Page Length (0Ah)
2 Reserved EER PER DTE DCR
3 Verify Retry Count
4 Verify Correction Span
5 – 9 Reserved
10 – 11 Verify Recovery Time Limit
Field
Default
Value
Description