Filter
Top Products
3-6 Maxtor Atlas 10K V
3.4 HARDWARE OPTIONS
3.4.1 Configuration Jumpers and Connections
This section includes setup and configuration information for Maxtor Atlas 10K V
drives. These disk drives include
• The 16-bit multimode Ultra320 SCSI, wide version with 68-pin SCSI
connector,
• The 16-bit multimode Ultra320 SCSI, version with SCA-2 80-pin
connector.
Specific individual settings for each drive type are described in Sections 3.5.1
through 3.5.4.
3.4.2 Jumper Options on the 68-Pin Wide PCB
This section describes how to configure the jumpers on Maxtor Atlas 10K V disks
with 68-pin SCSI interface connectors. The following features are jumper-
selectable:
• SCSI ID (0), (1), (2), (3) – SCSI Bus Device Identification
•Delay Spin
• Single-Ended, Disable LVD
• Busy Out (Remote LED)
• Write Protect
•Stagger Spin
Note: The disk drive does not support on-board SCSI termina-
tion.
Note: The configuration of a Maxtor Atlas 10K V hard disk
drive depends on the host system in which it is to be in-
stalled. Figure 3-3 shows the printed circuit board (PCB)
assemblies for 68-pin SCSI configurations, indicating the
jumpers that control some of these options.
CAUTION: Before you begin, review the Safety, ESD, and Handling precau-
tions described at the beginning of this manual to avoid personal in-
jury or damage to equipment.