Filter
Top Products
Maxtor Atlas 10K V 5-139
5.36 SEEK (6) Command (0Bh)
The SEEK (6) command uses a 6-byte Command Descriptor Block to request the
drive to send the drive heads to the requested Logical Block Address. The drive
responds by placing the heads at the correct Logical Block Address. When the heads
are at the specified Logical Block Address, they are not guaranteed to stay in that
position since periodic calibrations may send them to a different cylinder. The data
format is shown in Table 5-189.
Table 5-189 SEEK (6) Command Descriptor Block-Data Format
Bit
Byte
76543210
0 Operation Code (0Bh)
1 Reserved Logical Block Address
2 - 3 Logical Block Address
4 Reserved
5 Control