Filter
Top Products
5-44 Maxtor Atlas 10K V
Table 5-65 Verify Error Recovery Page-Field Descriptions (Page 7)
5.12.9 Caching Page (08h)
The Caching Page controls the drive’s cache management policy. The data format and
field descriptions are described in Table 5-66 and Table 5-67 respectively.
Table 5-66 Caching Page-(Page 8)
Field
Default
Value
Description
PS 0
Parameters Savable. This bit is only used with the MODE SENSE command. A returned val-
ue of 1 indicates that the target is capable of saving the page in a non-volatile, vendor-specific
location. The bit is reserved with the MODE SELECT command.
EER 0 Enable Early Recovery. Not supported by the drive.
PER 0
Post Error Recovery. When the value is 1, the drive returns CHECK CONDITION status for
recovered errors, sets the sense key to RECOVERED ERROR, and posts the appropriate ad-
ditional sense code.
When set to the default value of 0, it causes the drive to return GOOD status in cases where
error recovery is invoked and is successful. The only recoverable error that can occur during
a VERIFY operation is a failed read that succeeds after retries.
DTE 0 Disable Transfer on Error. Not supported by the drive.
DCR 0
Disable Correction. When the value is 1, it disables ECC Firmware only (but not retries) on
the READ portion of a VERIFY operation. When set to the default value of 0, the ECC cor-
rection is always applied as a means of recovering erred data.
Verify
Retry Count
4
The Verify Retry Count specifies the number of retries that are attempted per sector on a
failed READ portion of a VERIFY operation.
Verify
Correction
Span
240
The Verify Correction Span specifies the maximum number of bits in a sector that the drive
is allowed to correct. A value less than the default value can cause an otherwise correctable
error to be reported as uncorrectable. If the initiator specifies a value larger than 80, the drive
rounds down to 80 without reporting the change. A value of 0 causes the drive to use its de-
fault value. The drive ignores any value in this field.
Verify
Recovery
Time Limit
0
The Verify Recovery Time Limit specifies (in milliseconds) the maximum time that a retry
is attempted on a failed sector during the read portion of a verify operation. The default value
of 0 indicates that there is no time limit. The minimum permissible is 100 milliseconds.
Bit
Byte
76543210
0 PS Rsvd Page Code (08h)
1 Page Length (12h)
2 IC ABPF CAP DISC Size WCE MF RCD
3 Demand Read Retention Priority Demand Write Retention Priority
4 – 5 Disable Pre-Fetch Transfer Length
6 – 7 Minimum Pre-Fetch
8 – 9 Maximum Pre-Fetch
10 – 11 Maximum Pre-Fetch Ceiling
12 FSW LBCSS DRA VS VS Reserved
13 Number of Cache Segments
14 – 15 Cache Segment Size
16 Reserved
17 – 19 Non-Cache Segment Size