Filter
Top Products
72
Administrators must also make sure that no Office applications run during an installation of the
Office 2013 Preview.
If you set the Display Level value to “basic” and SuppressModal to “yes”, users might be
prompted if any Office files are being used. Setting Display Level to “none” prevents prompting
users in these cases. The SuppressModal attribute does not prevent files in use messages
from being displayed. Only if Display Level is set to “none” are files in use messages
prevented from being displayed.
The Display element is used by Setup only if Setup finds the Config.xml file in the same folder
as setup.exe, or if you specify the Config.xml file by using the Setup /config command-line
option. If Setup uses the Config.xml file in the product folder, Setup uses the default display
options.
Example
<Display Level="none" CompletionNotice="no" SuppressModal="yes" AcceptEula="Yes" />
DistributionPoint element
Specifies the fully qualified path of the network installation point from which the installation is to run.
Syntax
<DistributionPoint Location="path" />
Attributes
The following table describes DistributionPoint element attributes and values.
DistributionPoint attributes
Attribute
Value
Description
Location
path
The fully qualified path of the network
installation point from which the
installation is to run.
Remarks
If this is not specified, Setup assumes that the Setup.exe file is located at the root of the network
installation point.
Note:
The DistributionPoint element is used by Setup only if Setup finds the Config.xml file in the
same folder as setup.exe, or if you specify the Config.xml file by using the Setup /config
command-line option. If Setup uses the Config.xml file in the product folder, it ignores this
element because the network installation point has already been found.