Filter
Top Products
6-9
Chapter 6
Installing Options
7. Install the Hard Disk and tighten
the four screws.
(Use a plus screwdriver.)
8. Connect the Hard Disk cable to
the Hard Disk connector on the
controller board.
The Hard Disk can be installed
only when the Adobe PostScript
ROM-DIMM is installed.
9. Close the metal cover and tighten
the four screws.
Attach the right side cover.
10. Close the upper cover.
11. Connect the power cord to the
printer and then turn the printer
on.
→ See “Connecting the power
Cord” page 2-9.
→ See “Turning the Printer ON
and OFF” page 2-10.
4. Installing the Adobe Postscript DIMM and Hard Disk
NOTE
Options6.frm 9 ページ ２００３年１１月１８日 火曜日 午前９時５２分