Mitsubishi Electronics Q06HCPU Electronic Accessory User Manual


 
5 - 3 5 - 3
MELSEC-Q
5 POWER SUPPLY MODULE
Performance Specifications
Item
Q61SP
Base loading position Slim type power supply module loading slot
Applicable base unit Q3
SB
100 to 240VAC
+10%
-15%
Input power supply
(85 to 264VAC)
Input frequency 50/60Hz ±5%
Input voltage distortion factor Within 5% (refer to section 4.3.1)
Max. input apparent power 40VA
Inrush current 20A within 8ms
5VDC 2A Rated output
current
24VDC ——
5VDC 2.2A or more Overcurrent
protection*1
24VDC ——
5VDC 5.5 to 6.5V Overvoltage
protection*2
24VDC ——
Efficiency 70% or more
Allowable momentary power failure
period*3
Within 20ms
Dielectric withstand voltage
Across inputs/LG and outputs/FG
2830VAC rms/3 cycles (2000 m (6562 ft.))
Insulation resistance
Across inputs and outputs (LG and FG separated), across inputs and LG/FG, across outputs
and FG/LG 10M
or more by insulation resistance tester
Noise durability
• By noise simulator of 1500Vp-p noise voltage, 1
s noise width and 25 to 60Hz noise
frequency
• Noise voltage IEC61000-4-4, 2kV
Operation indication LED indication (lit at 5VDC output)
Fuse Built-in (Unchangeable by user)
Application
ERR contact (contact switched off (opened: normally closed contact) at an error stop of CPU
module), for CPU module operating status output
Rated switching voltage,
current
24VDC, 0.5A
Minimum switching load 5VDC, 1mA
Response time OFF to ON: 10ms max. ON to OFF: 12ms max.
Life
Mechanical : More than 20 million times
Electrical : More than 100 thousand times at rated switching voltage, current
Surge suppressor No
Contact
output
section
Fuse No
Terminal screw size M3.5 × 7
Applicable wire size 0.75 to 2mm
2
Applicable solderless terminal RAV1.25 to 3.5, RAV2 to 3.5
Applicable tightening torque 66 to 89N•cm
H 98mm (3.86inch)
W 27.4mm (1.08inch)
External
dimensions
D 104mm (4.09inch)
Weight 0.18kg