Mitsubishi Electronics WD8700U Projector User Manual


  Open as PDF
of 79
 
EN-46
ZOOM(V)
Theverticalimagesizeisadjustedusingthecenteroftheimageasthebasepoint.Thesettingrangeis50%to
500%.
HORIZ. POSITION
Use to adjust the horizontal position of the projected image. The setting range is -999 to +999.
VERT. POSITION
Use to adjust the vertical position of the projected image. The setting range is -999 to +999.
RASTER POSITION(H)
When the supplied image is not projected on the entire display area, the horizontal location of the projected image
can be adjusted within the area. The setting range is -640 to +640.
RASTER POSITION(V)
When the supplied image is not projected on the entire display area, the vertical location of the projected image can
be adjusted within the area. The setting range is -400 to +400.
RESET
Press the ENTER button to reset the USER settings.
Important:
• Noisemayappearonthescreendependingonthecombinationofthetypeofthevideosignalbeingprojected
and the setting values of the ZOOM(H), ZOOM(V), HORIZ. POSITION, VERT. POSITION, RASTER POSITION(H),
and RASTER POSITION(V). In such cases, set these values in the range where the image is displayed without
noise.
Saving the setting in the SIGNAL MEMORY:
You can save the settings of the SIGNAL menu using the SIGNAL MEMORY.
• Youcansavemultiplesignalsettingsforonesignalformatandswitchthemethodaccordingtouse.
Up to 8 settings can be saved. (See page 31 for menu setting.)
[Example]
AUTO
Memory number in the SIGNAL MEMORY
1-720p50 2-720p50 3-1080i60 4-xxx ••• 8-xxx
SIGNAL menu ANY SIGNAL 720p50 720p50 1080i60 - -
To save the setting in the SIGNAL MEMORY:
1. Display the SIGNAL menu.
2. Select SIGNAL MEMORY while AUTO is selected in the MEMORY CALL by pressing the or button.
3. Select MEMORIZE and press the ENTER button.
4. Select your desired memory number by pressing the or button.
5. Press the ENTER button to save the memory.
• To save the new setting, select a new memory number. The memory number of the MEMORY CALL changes to a
new one after saving the setting.
• Whenthesettingintheselectedmemorynumberischanged,thechangedsettingisautomaticallysaved.
To select the saved memory by the MEMORY CALL:
You can call up and switch the setting saved in the SIGNAL MEMORY.
1. Display the SIGNAL menu.
2. Select MEMORY CALL by pressing the or button.
3. Select your desired memory number by pressing the or button.
• Onlythememorynumberrelevanttotheinputsignalcanbeselected.
• Whenthesamesignalisinputonthenexttime,theselectedmemorynumberisstillmemorized.
Adjusting projected images (continued)
 previous next