Filter
Top Products
613 Reference point off supply.
614 Portion of field off supply or there may be an invalid
character in the packet.
703 The printer sensed a calibration of different-sized black
marks. Make sure the correct supply type is loaded.
704 Printer has not sensed a supply mark within the
specified number of inches or is out of supplies. Check
the supply tracking, supply marks, black mark sensor
position, and supply roll for binding. Press
E and try
to continue printing. Change supply.
750 Printhead is overheated. Turn off the printer.
751 Printer did not sense a black mark when expected. For
errors 751-753, check the supply tracking, supply
marks, black mark sensor position, and supply roll for
binding. Press
E and try to continue printing. Change
supply.
752 Printer sensed a mark in the wrong place.
753 Printer sensed a mark that is too long.
754 Check for a ribbon jam or remove any slack in the
ribbon by turning the take-up reel clockwise. Load a
new ribbon.
755 Printhead is open. Close the printhead.
756 Load supplies.
757 Load supplies (supply length mismatch), because the
calibrated supply length differs by plus or minus .25
inches from the format. Press
F.
758 Either the supply is not seen or the on-demand sensor
is broken. Check for a label jam, clear the supply path,
or reload supplies. This error may occur if you remove
a label too quickly in the on-demand mode.
Diagnostics & Troubleshooting
12-9