Filter
Top Products
Reset to Default Values
To change the setting, from the Main Menu select Setup, Port
Settings, then Serial Comm. Then, follow these steps.
1. Press r until you see
SERIAL COMM
l Reset
2. Press
N.
Are you sure?
No r
3. Press l or r to make your selection, then press
N. If you
select "Yes," the following defaults are restored: 9600 baud,
No parity, 8 bit word length, and 1 stop bit.
4. Press
E until you see the Main Menu.
Parallel Communications
The parallel communications menu allows you to set the values
for the active parallel port. The values are listed in the table
below.
Option Choices Default
Port External/Internal External
Mode Compatible/IEEE-1284 Compatible
(Centronics mode)
Communication Values
8-5