Filter
Top Products
Supply Type
You can print on aperture, black mark, die cut, or continuous
supplies. You have to tell the printer which supplies you are
using.
If you are using edge aperture supplies, use
the die cut setting. If you are using center
aperture supplies, use the aperture setting.
To change the setting, from the Main Menu, select Setup, then
Supply. If password protection in enabled, press
F three times,
then press
N before you see the Setup Menu options. Then,
follow these steps.
1. Press l or r until you see
SUPPLY
l Supply Type r
2. Press
N to set the supply type option. The current setting is
displayed, for example:
SUPPLY TYPE
l Black Mark r
3. Press l or r to see the other options. After you display the
option you want, press
N. Press
E until you see the Main
Menu.
Setting Supply Options
6-3