Filter
Top Products
Hardware Installation
Installing the Industio CP-134U Series Board
Step 1: Power off the PC.
Warning! To avoid damaging your system and board, make sure your computer is
turned off before installing any board.
Step 2: Remove the PC’s cover.
Step 3: Remove the slot cover bracket if there is one.
Step 4: Plug the Industio CP-134U Series control board firmly into a free 32-bit PCI slot,
or the CP-134U Series board into both a 32-bit/64-bit slot.
Step 5: Fasten the holding screw to fix the control board in place.
Step 6: Replace the system cover.
Step 7: Power on the PC. The BIOS will automatically set the IRQ and I/O address.
Note! Each board must occupy one unique IRQ and two 8-byte I/O addresses,
which are assigned automatically by the PCI BIOS. However, you can
select a free IRQ number manually via the PC’s BIOS setup for the PCI slot,
but normally this method is not available for the I/O address. The possible
IRQ numbers are 2, 3, 4, 5, 7, 10, 11, 12, and 15. The possible I/O addresses
are from 0x0000 to 0xFFFF.
Step 8: Proceed with the software installation discussed in the next chapter, “Software
Installation.”
Industio CP-134U Series User’s Manual
2-7