Filter
Top Products
should not conflict with other COM numbers in use. In this “Individual Port Setting”
dialog box, there are two ways to map physical ports to COM numbers, depending on
whether you check the “Auto Enumerating COM Number” box.
If “Auto Enumerating COM Number” is checked, and the COM number of the first
port is specified, then subsequent ports are mapped to the next available COM number.
For instance, if the first port is mapped to COM3, then the second port is mapped to
COM4.
If “Auto Enumerating COM Number” is not checked, specify the COM number for
each port separately. For example, the second port could be mapped to COM10, and
the first port mapped to COM3.
Rx FIFO Trigger
You may choose from Rx FIFO trigger levels of from 1 to 62 bytes, with the default
value set at 56 bytes.
Tx FIFO Size
You may choose a Tx FIFO size from between 1 and 64 bytes with the default value
set at 64 bytes.
9. Click [OK] in the “Port #” and “Property” dialog boxes to go back to the “MOXA
Smartio/Industio Configuration Panel” dialog box.
Note ! If you need to install more than one board, click [Add] and repeat steps 6
to 8 to configure the additional board. Up to four Industio CP-134U Series boards
can be installed in one NT system.
Click [OK] to finish the configuration.
Industio CP-134U Series User’s Manual
3-6