Filter
Top Products
Software Installation
Port Configuration Stage
This stage presents the steps for configuring the Industio CP-134U Series board’s ports
under Windows 95/98.
After the driver is installed, the CP-134U Series Installation window will appear
automatically, and the port mapping will be done automatically by the system.
If one CP-134U Series board was already installed, and another CP-134U Series board is
plugged in, then the system will prompt you to take care of port configuration, as discussed
in this section.
1. Click on a specific port.
2. Click on the [Port Setting] button to open the Port X window.
3. Select a COM number for the specific port from the Port Number pull-down list.
Note! Step 4 is optional if you want to assign COM numbers to Ports manually.
4. Check the [Auto Enumerating COM Number] check-box to number ports
sequentially. For example, if COM 3 is assigned to Port 1, then COM 4 will be
automatically assigned to Port 2.
Note! You may skip Steps 5 to 8 if the system does not require special
performance tuning.
5. Select an Rx FIFO Trigger from the Rx FIFO Trigger pull-down list.
Rx FIFO trigger levels of from 1 to 62 bytes are available, with the default value set at
56 bytes.
6. Check the [Set the change to all ports] check-box if you want to apply the just
Industio CP-134U Series User’s Manual
3-15