Filter
Top Products
MTASR1-100 Owner’s Manual
138
14. Select the Management Type that corresponds to what was provided by your Frame Relay network
provider at the time of subscription. In this example lets assume that it is Annex D. So nothing has to be
done in this dialog box.
15. Click on the DLCI button to display the Frame Relay DLCI dialog box.
16. To map DLCI 50 to logical WAN 1, click on the DLCI numeric dialog box and enter the number 52. When
the number 52 is entered, all the other groups in the dialog box become active.
17. Click on the Protocol Stacks Mapped group IP Address option button to map the IP protocol to DLCI.
18. Click on the IP Address down arrow and a drop down list box displays the IP addresses for the stack.
Click on the WAN port IP Address 200.2.9.2.
19. Move to the Settings (in Bits/second) group and lets leave the Committed Information at 56000, but
change the Excess Burst Rate (Be) from 0 to 9000. Click on the 0 and back space thru the 0 and then
enter 9000.
The reason we are setting up these values is that in this example, the DLCI is allocated 64K in which the
CIR could be 64K with a Be of zero. Maybe a better allocation would be a CIR of 56K and a Be of 9K.
This may cut down on conjestion on the frame relay network.
20. Now move to the Mode group and click on the Adhere to CIR + Be option button.
21. Click on the Add button to configure DLCI 52.