Filter
Top Products
Chapter 4 - Software Loading and Configuration
41
Frame Relay Procedure
42 The Frame Relay DLCI Default Setup dialog box is displayed. If frame relay is being used as the WAN,
proceed to the next step. If frame relay is not being used, click on the OK button and proceed to step 52.
The DLCI has to be mapped to the logical WAN 1 address of the protocol stack for the LAN that is
connected to the RouteFinder
100
. The remote logical WAN 1 address for this DLCI path has to be in the
same network.
43 If the default DLCI 50 is being mapped to a logical WAN, click on the Configured DLCI's 0050 and map
the default DLCI to a protocol stack.
Click on the DLCI numeric dialog box and enter a DLCI number that was provided by your service
provider at subscription time. Do Not hit the ENTER key at this time. If you hit the ENTER key,
installation continues without adding your DLCI information. You can recover from this by configuring
frame relay from the Main Menu after installation. Refer to Chapter 5 for a description of the frame relay
configuration, if necessary.
44 To map this DLCI to a protocol stack, click on the protocol stack check box for the protocol of your LAN.
Then click on the down arrow for that protocol and the drop down dialog box presents the WAN
addresses. Choose the logical WAN address by clicking on the address.
45 Click on the Committed Information Rate numeric box in the Settings (in Bits/second) category and
enter the CIR value provided by your service provider at subscription time for this DLCI.
46 Click on the Excess Burst Rate (Be) numeric box in the Settings (in Bits/second) category and enter the
Be value provided by your service provider at subscription time for this DLCI.
47 Click on As Fast as Possible check box in the Mode category. Multi-Tech recommends this as the initial
setting and if you experience loss of data choose one of the other two settings.
48 Click on the Mgnt Type group and choose the management type that is supported by your Frame Relay
network. The management type is supplied by your service provider at subscription time.
49 Click on the Add button to save the parameters for this DLCI.
50 Repeat steps 43 through 49 for each new DLCI.
51 Click on the OK button when you have entered all your DLCIs.