Filter
Top Products
Chapter 4 - Software Loading and Configuration
39
IP Procedure
27 If you clicked OK from the IPX Protocol Default Setup dialog box (step 15), the IP Protocol Default Setup
dialog box is displayed.
28 To change the IP parameters do not click OK, proceed to the next step. Clicking on the OK button
advances to the WAN Port Default Setup dialog box. The WAN Port Default Setup starts at step 36.
29 Assign an acceptable unique IP address to the EtherNet port for the RouteFinder
100
on LAN 1. Write the
IP address in the space provided in Figure 4-2 for LAN 1 RouteFinder EtherNet IP Address.
30 Assign an acceptable unique IP address to the WAN port for the RouteFinder on LAN 1. Write the IP
address in the space provided on the IP Protocol Worksheet.
Figure 4-2. IP Protocol Worksheet
31 Assign an acceptable unique IP address to the EtherNet port for the RouteFinder
100
on LAN 2. Write the
IP address in the space provided in Figure 4-2 for LAN 2 RouteFinder EtherNet IP Address.
32 Assign an acceptable unique IP address to the WAN port for the RouteFinder on LAN 2. Write the IP
address in the space provided on the IP Protocol Worksheet.
33 Change the default IP Address, Subnet Mask, and Frame Type, to the values you have assigned to your
LAN port.
34 Change the default Address, Subnet Mask, and Remote Address for the WAN to the values you have
assigned to your LAN.
35 Click on OK when you are satisfied with your selections.