Filter
Top Products
Getting started
1.28
2.
To change the setting, use the numeric keypad to enter the desired number of
rediallings. You may enter 2 to 5. In this example, we’ve entered 3.
Set # Of Redials
# (2-5): 3
3.
Press
ENTER
to save the setting.
Set Redial Interval
Inter. (3-5): 3
If the number of rediallings (in times) and redial interval (in minutes) you see
is acceptable, skip to step 5.
Otherwise, proceed to step 4.
4.
To change the setting, use the numeric keypad to enter the desired number.
5.
Press
ENTER
to save the setting.
Cancelling memory transmission or automatic redial:
an introduction to
REVIEW COMMANDS
To cancel either a memory transmission (see page 1.23) or an automatic redial, you’ll
use
REVIEW COMMANDS
.
First, a bit of explanation, however…
• When your machine stores a document for automatic redial, that makes that
document one of those stored commands.
• Because your fax machine can store multiple transmission commands in memory,
it keeps track of each command by assigning it a command number — e.g., “C00.”
The Review function gives you the power not only to check on (review) each
command currently pending in your machine’s memory but also to detect a command
if you decide not to go ahead with the command and send the document.
1.
If the machine is in Fax mode, proceed to step 2.
If it is in Copy mode, press
COPY
/
FAX
to change to Fax mode.
2.
Press
REVIEW COMMANDS
once.
The
LCD
shows the first command, indicated by its command number and the
phone number the command will dial (or, perhaps, redial).
C00:5552009
Program/Cancel
3.
If this is a command you want to cancel, skip to step 5.
If this is not a command you want to cancel, proceed to step 4.
4.
Press
PROGRAM
to continue on to the next command in the command queue,
then go back to step 3.
5.
Press
CANCEL
. The display shows:
C00:5552009
Check Program/Cancel
6.
If you do want to cancel this command, press
CANCEL
again.
If you want to avoid cancelling this command but do want to review other
commands in the queue, press
PROGRAM
to view the next command, and go
back to step 3.
If you want to stop reviewing the stored commands, press
STOP
to return the
machine to standby mode.
This function gives you enormous control over some of your machine’s most
powerful features. For more information on the
REVIEW COMMANDS
function, please
see pages 2.21–2.22.