NCR S26 Server User Manual


 
Setting Hard Disk ID Options
NCR S26 Hot Plug Server User Guide D-11
Setting Hard Disk ID Options
You have two options in setting the hard disk ID:
Strapping the SCSI IDs on the hotplug backplane
Strapping the SCSI IDs on the drive
Strapping the SCSI IDs on the Backplane
The wide SCSI hot-swap drive tray includes an 8/12-pin ID cable. See item 2
on Figure D-2. This cable allows you to define the hard disk ID using the ID
switches (see item 9 in Figure D-1) on the backplane board.
The figure below shows how to connect the 8/12-pin ID cable to the drive.
Figure D-7. Connecting the ID Cable to the Drive
Wide SCSI J1-A PowerBIT 0
The other end of the ID cable connects to the hot plug drive tray. See item 2 in
Figure D-2.