Filter
Top Products
PCI System Configuration
NCR S26 Hot Plug Server User Guide 4-15
PCI System Configuration
The PCI System Configuration, as shown in the figure below, permits you to
specify the settings for your PCI devices.
Figure 4-5. PCI System Configuration
PCI System Configuration
PCI IRQ Setting
PCI Slot 1
PCI Slot 2
PCI Slot 3
PCI Slot 4
PCI Slot 5
Onboard VGA
Onboard SCSI
VGA Palette Snoop
On Board SCSI
Boot Device
[Auto]
[ Disabled ]
[ Enabled ]
[ Disabled ]
...........
...........
...........
...........
...........
...........
........
.......
........
............
.........
INTA
[--]
[--]
[--]
[--]
[--]
[--]
[--]
INTB
[--]
[--]
[--]
[--]
[--]
INTC
[--]
[--]
[--]
[--]
[--]
INTD
[--]
[--]
[--]
[--]
[--]
= Move Highlight Bar,
PgDn/PgUp = Move Screen, F1 = Help, Esc = Exit
= Change setting,
Page 1/1
PCI IRQ Setting
This parameter allows for Auto or Manual configuration of PCI devices. If
you use plug-and-play (PnP) devices, you can keep the default setting Auto.
The system then automatically configures the PnP devices. If your PCI device
is not a PnP, you can manually assign the interrupt for each device. Refer to
your adapter board documentation for technical information.
Note: When the PCI IRQ Setting is set to Auto, all the IRQ setting fields
become gray and non-configurable.