Filter
Top Products
Installation
D-14 Hot Plug Backplane
Installation
This section describes the hot plug backplane installation procedures.
Using the System Board SCSI Connectors
To install the backplane when you are using the SCSI connectors on the
system board, follow these steps:
1. Set the terminator switches on the backplane according to your planned
SCSI channel configuration. Refer to the “SCSI Channel Configurations”
section earlier in this appendix for the channel configurations.
2. Define the SCSI drive IDs by setting the SCSI ID switches or jumpers on
the drive.
3. Remove all the old hard disk drive trays from the system, if any.
4. Install the backplane and secure it with eight screws.