Filter
Top Products
4-41
Setting SPAN
The setting procedure for SPANNING OF RAID1 and SPANNING OF RAID5 are shown below
SPANNING OF RAID1
1. Open the configuration creation screen.
Select "Configure" → "New Configuration" from the TOP menu to display the screen shown below. This is
the Channel-1 menu screen where the cursor is put on ID=0 position:
2. Select ID-0/1 hard disks.
Pressing Space changes the display for Channel-1, ID=0 to "ONLIN A01-01" where "A01-01" is blinking.
(The cursor automatically moves to Channel-1, ID=1.) In the same way, press Space on Channel-1, ID=1.
(Where "A01-02" is blinking, the cursor moves to Channel-1, ID=2.) After selecting 2 hard disks (Channel-1,
ID=0/Channel-1, ID=1), press Enter to determine the settings. (Display on each hard disk stops blinking.)