Filter
Top Products
9-24
Non-hot-plug PCI Boards
This section describes the procedure for installing or removing a non-hot-plug PCI board.
Installation
Install a board in a PCI board slot as follows.
IMPORTANT:
PCI board slots #6 to #9 can accept 3.3V and universal PCI boards.
PCI board slots #1 and #2 can accept 5V and universal PCI boards.
NOTES:
Before installing the PCI board, make sure that the terminal section of the board mates
with the connector of the PCI board slot.
Insulators are installed between the PCI board slots. They are for protecting the PCI
board already been installed. Take care not to remove or damage the insulator when
installing or removing a PCI board. If the insulator is taken off, reinstall the insulator in
place.
1. See the section "Preparing for Installation and Removal" described earlier to prepare.
IMPORTANT: To avoid damage to the system and devices, always turn off the system
before installing a non-hot swap board.
2. Remove the rear access cover.
3. Locate the slot to install a board.
4. Press the retention tab at the tip of the additional slot cover to unlock and open the tab.
IMPORTANT: Do not open the retention tab to 90 degrees or more. Doing so could
damage the tab.
1
2