Filter
Top Products
8-38
About System Log when re-starting the system on Windows Server 2003
Type: Warning
Source: E100B
Event ID: 4
Description: Adapter Intel(R) PRO/100 Network Connection: Adapter Link Down
→ When re-starting the system without connecting the network cable, this log may be found in system
event log.
But this has no effect on the behaviour of LAN driver.
Confirm that the system is connected with the LAN cable properly.
If 100Base LAN port is not used, disable 100Base LAN on device manager or disable it on BIOS
configuration. Then, the log will not be registered.
Event logs in using SNMP Service in Windows Server 2003
Event Type: Warning
Event Source: EvntAgnt
Event Category: None
Event ID: 1015
Description: TraceLevel parameter not located in registry;
Default trace level used is 32.
Event Type: Warning
Event Source: EvntAgnt
Event Category: None
Event ID: 1003
Description: TraceFileName parameter not located in registry;
Default trace file used is .
→ The system will not be affected by these event logs. SNMP will not be affected either, so that you can
ignore these logs.
A PCI board is not recognized.
• Is the PCI board installed correctly?
→ Confirm that the PCI board is installed in the slot correctly.
• Is the proper IRQ assigned for the board?
→ Assign the proper IRQ by referring to Chapter 4.
• Is "Disabled" specified in [Option ROM] for the slot to install SCSI card (excluding the array board used
for operating system boot)?
→ Check the settings with the BIOS setup utility.
<Menus to check: [Advanced] - [PCI Configuration] - [PCI Slot n] (n: PCI slot number of installed
board) - [Option ROM Scan]>
• Is "Disabled" specified in [Option ROM] for the slot for added network board which is not used for
network boot?
→ Check the settings with the BIOS setup utility.
<Menus to check: [Advanced] - [PCI Configuration] - [PCI Slot n] (n: PCI slot number of installed
board) - [Option ROM Scan]>