Filter
Top Products
8-42
Specified to join the Domain, but the system is installed as Workgroup.
→ When the setup fails to join the Domain during the installation, it will install the system as Workgroup.
Open [System] in Control Panel to specify joining the Domain.
Specified large value as partition size, but when Windows 2000 is actually started, the system partition is created
by 4095 MB.
→ Is the [Partition Size] specified by the value larger than the real area? If you want to create one partition
in all area of the hard disk (excluding the maintenance area) to install the operating system, specify [All
Area].
Windows 2000 started with different display resolution from the specified value.
→ If the specified display resolution can not be used, the system will use the nearest value or the default
value of the driver.
Entered the incorrect Product ID/CD key.
→ Even if you entered the incorrect Product ID/CD key, Express Setup will start. However, the setup will
stop and asks you to re-enter the correct value. Also in this case, input request will occur when rebooting
after GUI setup completed during Express Setup. If these 2 inputs are done correctly, there is no problem
on Windows 2000 setup.
Unable to specify the details of network adapter.
→ In Express Setup, you can not specify the details of Network adapter. Specify them from Control Panel
after starting Windows 2000.
Windows 2000 is started with network adapter that has not been specified during Express Setup
→ Windows 2000 will install the recognized network adapter specified as default value. If you want to
modify the specification, it can be done from Control Panel after starting Windows 2000. Also, a network
adapter that has been specified during Express Setup but is not connected will not be setup, though the
protocol will only be installed.
Connected more than two network adapters and specified a different protocol for each adapter, but all the
protocols are specified on either adapter.
→ It's a design. Each adapter is specified so that all the installed protocols can be used.
The values that cannot be specified during Express Setup will all be specified by default value.
When more than two network adapters are specified, the detailed specification of TCP/IP protocol are all set to
use DHCP.
→ When more than two network adapters are specified, the detailed specification of the protocol may all be
set by default value. Re-specify the details from Control Panel.
Not more than two network adapters are connected, but the detailed specification of the protocol are all set by
default. (e.g. Specified IP Address on TCP/IP, but DHCP is specified)
→ Are you specifying more than two protocols?
In this case, the situation will be the same as connecting more than two Network adapter, so the detailed
specification of the protocol are all set by default.
Re-specify the details from Control Panel after starting the operating system.