Filter
Top Products
8-45
Problems with Master Control Menu
The master control menu fails to appear:
• Is your system Windows NT 4.0 or later, or Windows 95 or later?
→ The Master Control menu is supported by Windows NT 4.0 and Windows 95.
• Is Shift pressed?
→ Setting the CD-ROM with Shift pressed down cancels the Autorun feature.
• Is the system in the proper state?
→ The menu may not appear depending on the system registry setting or the timing to set the CD-ROM.
In such a case, start the Explorer and run \MC\1ST.EXE in the CD-ROM.
Problems with Configuration Diskette Creator
<Common to Windows 2000>
The bit map of the Configuration Diskette Creator window is not displayed correctly during setting of
setup information. (When the Trekking command is used)
→ If the specified number of colours is fewer than 256 in the display setting, the bit map is not displayed
correctly, but the setup information can be displayed correctly.
The Point to Point tunnelling protocol cannot be set.
→ The protocol is not supported at present. After installation, set the protocol through Control Panel. In this
case, rebooting is not necessary.
The details of a network adapter cannot be set.
→ Configuration Diskette Creator is unable to set the details of network adapters. Start Windows 2000, and
set the details through Control Panel.