NEC NP-UM352W Projector User Manual


  Open as PDF
of 151
 
5
1. Introduction
Removing and Attaching the Cable Cover
Afternishingconnections,attachthesuppliedcablecovertoproperlyhidethecables.
CAUTION:
• Besuretotightenthescrewsafterattachingthecablecover.Failuretodosomaycausethecablecovertocome
offandfall,resultingininjuryordamagetothecablecover.
• Donotputbundledcablesinthecablecover.Doingsomaydamagethepowercord,resultinginare.
• Donotholdthecablecoverwhilemovingtheprojectorordonotapplyexcessiveforcetothecablecover.Doingso
maydamagethecablecover,resultingininjury.
Removingthecablecover
Toolneeded:
• Phillipsscrewdriver(plus-head)about9cm/4inchesinlength
9 cm/4 inches
1. Loosen the cable cover screws until the Phillips screw-
driver goes into a freewheeling condition.
 •Thesescrewsremaintostay.
2. Remove the cable cover.
❶Push up the cable cover slightly and rotate it to release.
❷Pull the cable cover while pushing and holding the arrow
part
 Ifyoundittohardtoreleasethecablecover,tryholdingit
slightly up.
1
2
 previous next