Filter
Top Products
User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
7-62 Switching Commands
202-10010-01
config radius server primary
This command specifies which configured server should be the primary server for this RADIUS
client. The primary is the server that is used by default for handling RADIUS requests. The
remaining configured servers are used only if the primary server cannot be reached. A maximum
of three servers can be configured on each client. Only one server can be configured as the primary
server. If a primary server is currently configured and this command is issued, the server specified
by the IP address used in this command will become the new primary server. The IP address
specified must match that of a configured server.
Format config radius server primary <ipaddr>
config radius server msgauth
This command enables or disables the message authenticator attribute for the specified RADIUS
server. Enabling the message authenticator attribute provides additional security in the connection
between the RADIUS client and the RADIUS server. Some RADIUS servers require enabling the
message authenticator attribute for authentication requests from the RADIUS client to be
accepted. The IP address specified must match that of a configured server.
Format config radius server msgauth <ipaddr> <enable/disable>
show radius summary
This command displays the following RADIUS configuration items for the switch.
Format show radius summary
Current Server IP address The IP address of the server currently used for authentication.
Number of Configured
Servers The number of RADIUS servers that have been configured. This value will be in
the range of 0 and 3.
Max Number of Retransmits The configured value of the maximum number of times a request packet is
retransmitted.
Timeout Duration The configured timeout value, in seconds, for request retransmissions.
Accounting Mode The configured value for RADIUS accounting mode indicating if accounting is
currently enabled.
show radius server summary
This command displays the configured RADIUS servers.
Format show radius server summary