Filter
Top Products
User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
7-38 Switching Commands
202-10010-01
config garp leavealltimer
This command sets how frequently Leave All PDUs are generated per port. A Leave All PDU
indicates that all registrations will be unregistered. Participants would need to rejoin in order to
maintain registration. The value applies per port and per GARP participation. The time may range
from 200 to 6000 (centiseconds).
Note: This command has an effect only when GVRP is enabled.
Default 1000 centiseconds (10 seconds)
Format config garp leavealltimer <slot.port/all> <200-6000>
show igmpsnooping
This command displays IGMP Snooping information. Configured information is displayed
whether or not IGMP Snooping is enabled. Status information is only displayed when IGMP
Snooping is enabled.
Format show igmpsnooping
Admin Mode This indicates whether or not IGMP Snooping is active on the switch.
Query Interval Time This displays the IGMP Query Interval Time. This is the amount of time a
switch will wait for a report for a particular group on a particular interface
before it sends a query on that interface. This value may be configured
Max Response Time This displays the amount of time the switch will wait after sending a query on an
interface because it did not receive a report for a particular group on that
interface. This value may be configured.
Multicast Router Present
Expiration Time If a query is not received on an interface within this amount of time, the
interface is removed from the list of interfaces with multicast routers attached.
This value may be configured.
Interfaces Enabled for
GMP Snooping This is the list of interfaces on which IGMP Snooping is enabled.
The following status values are only displayed when IGMP Snooping is enabled.
Multicast Control Frame
Count This displays the number of multicast control frames that are processed by the
CPU.
Data Frames Forwarded
by the CPU This displays the number of data frames that are forwarded by the CPU.