Filter
Top Products
User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
Switching Commands 7-57
202-10010-01
config users passwd
This command changes the password of an existing operator. The password is up to eight
alphanumeric characters. The name and password are not case-sensitive.
When a password is changed, a prompt will ask for the operator’s former password. If none, press
enter.
Default Blank (indicating no password)
Format config users passwd <user>
config users delete
This command removes an operator.
Format config users delete <name>
Note: The admin user account cannot be deleted.
config users snmpv3 authentication
This command specifies the authentication protocol to be used for the specified login user. The
valid authentication protocols are
none, md5 or sha. If md5 or sha are specified, the user login
password will be used as the snmpv3 authentication password. The
<user> is the login user name
for which the specified authentication protocol will be used.
Default no authentication
Format config users snmpv3 authentication <user> <none/md5/
sha>
config users snmpv3 encryption
This command specifies the encryption protocol and key to be used for the specified login user.
The valid encryption protocols are
none or des. The des protocol requires a key, which can be
specified on the command line. The
key may be up to 16 characters long. If the des protocol is
specified but a key is not provided, the user will be prompted for the key. If
none is specified, a key
must not be provided. The
<user> is the login user name for which the specified encryption
protocol will be used.
Default no encryption
Format config users snmpv3 encryption <user> <none/des [key]>