Filter
Top Products
User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
7-36 Switching Commands
202-10010-01
participant basis. Permissible values are 10 to 100 centiseconds (0.1 to 1.0
seconds). The factory default is 20 centiseconds (0.2 seconds). The finest
granularity of specification is 1 centisecond (0.01 seconds).
Leave Timer Specifies the period of time to wait after receiving an unregistered request for an
attribute before deleting the attribute. Current attributes are a VLAN or
multicast group. This may be considered a buffer time for another station to
assert registration for the same attribute in order to maintain uninterrupted
service. There is an instance of this timer on a per-Port, per-GARP participant
basis. Permissible values are 20 to 600 centiseconds (0.2 to 6.0 seconds). The
factory default is 60 centiseconds (0.6 seconds). The finest granularity of
specification is 1 centisecond (0.01 seconds).
LeaveAll Timer This Leave All Time controls how frequently LeaveAll PDUs are generated. A
LeaveAll PDU indicates that all registrations will shortly be deregistered.
Participants will need to rejoin in order to maintain registration. There is an
instance of this timer on a per-Port, per-GARP participant basis. The Leave All
Period Timer is set to a random value in the range of LeaveAllTime to
1.5*LeaveAllTime. Permissible values are 200 to 6000 centiseconds (2 to 60
seconds). The factory default is 1000 centiseconds (10 seconds). The finest
granularity of specification is 1 centisecond (0.01 seconds).
Port GMRP Mode Indicates the GMRP administrative mode for the port. It may be enabled or
disabled. If this parameter is disabled, Join Time, Leave Time and Leave All
Time have no effect. The factory default is disabled.
Port GVRP Mode Indicates the GVRP administrative mode for the port. It may be enabled or
disabled. If this parameter is disabled, Join Time, Leave Time and Leave All
Time have no effect. The factory default is disabled.
config garp gmrp adminmode
This command enables or disables GARP Multicast Registration Protocol (GMRP) on the system.
The default value is disable.
Format config garp gmrp adminmode <enable/disable>
config garp gmrp interface mode
This command enables or disables GARP Multicast Registration Protocol on a selected interface.
The <slot.port> parameter identifies the interface on which to configure the mode. If an interface
which has GARP enabled is enabled for routing or is enlisted as a member of a LAG, GARP
functionality will be disabled on that interface. GARP functionality will subsequently be re-
enabled if routing is disabled and LAG membership is removed from an interface that has GARP
enabled.
Default disable
Format config garp gmrp interface mode <slot.port/all> <enable/disable>