Filter
Top Products
User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
Switching Commands 7-21
202-10010-01
config trapflags authentication
This command enables or disables the Authentication Flag.
Default enable
Format config trapflags authentication <enable|disable>
config trapflags bcaststorm
This command enables or disables the broadcast storm trap. When enabled, broadcast storm traps
are sent only if the broadcast storm recovery mode setting associated with the port is enabled (see
“config switchconfig broadcast” on page 24).
Default enable
Format config trapflags bcaststorm <enable|disable>
config trapflags linkmode
This command enables or disables Link Up/Down traps for the entire switch. When enabled, link
traps are sent only if the Link Trap flag setting associated with the port is enabled (see “config port
linktrap” on page 26).
Default enable
Format config trapflags linkmode <enable|disable>
config trapflags multiusers
This command enables or disables Multiple User traps. When the traps are enabled, a Multiple
User Trap is sent when a user logs in to the terminal interface (EIA 232 or telnet) and there is an
existing terminal interface session.
Default enable
Format config trapflags multiusers <enable|disable>
config trapflags stpmode
This command enables or disables the sending of new root traps and topology change notification
traps.
Default enable
Format config trapflags stpmode <enable|disable>