Filter
Top Products
User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
7-16 Switching Commands
202-10010-01
config serial baudrate
This command specifies the communication rate of the terminal interface. The supported rates are
1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200.
Default 9600
Format config serial baudrate <speed>
config serial timeout
This command specifies the maximum connect time (in minutes) without console activity. A value
of 0 indicates that a console can be connected indefinitely. The time range is 0 to 160.
Default 5
Format config serial timeout <0 - 160>
show serviceport
This command displays service port configuration information.
Format show serviceport
IP Address The IP address of the interface. The factory default value is 0.0.0.0
Subnet Mask The IP subnet mask for this interface. The factory default value is 0.0.0.0
Default Gateway The default gateway for this IP interface. The factory default value is 0.0.0.0
ServPort Configuration
Protocol Current Indicates what network protocol was used on the last, or current power-up cycle,
if any.
Burnedin MAC Address The burnedin MAC address used for in-band connectivity.
config serviceport parms
This command sets the IP address, the netmask and the gateway of the router.
Format config serviceport parms <ipAddr> <netmask> [gateway]
config serviceport protocol
This command specifies the servicePort configuration protocol. If you modify this value, the
change takes effect immediately.
Format config serviceport protocol <none|bootp|dhcp>