Filter
Top Products
GS108T Smart Switch Software Administration Manual
Configuring Switching 4-25
v1.0, December 2007
2. Select a radio button to enable or disable jumbo frames:
• Disable. Jumbo frames are disabled. This is the default setting.
• Enable. Jumbo frames are enabled.
3. Click Apply to confirm any settings changes.
Address Table
The Static Address table lists all the MAC addresses that you can specify. These addresses enable
the switch to forward traffic from these MAC addresses. The maximum number of trusted MAC
addresses is 256 per system. All source MAC addresses are trusted when the Trusted MAC list is
empty. For information about the Trusted MAC list, see
“Trusted MAC” on page 5-21. If the list
includes MAC addresses, any incoming traffic with a source MAC address that is not included in
the trusted MAC table is dropped.
Static Address
To configure a static MAC address:
1. Select Switching > Address Table > Static Address. A screen similar to the following one
displays.
.
2. The following static MAC address information is displayed. All fields are configurable:
• Interface. Specifies the interface (port) number to which the entry refers.
• MAC Address. Specifies the MAC address to which the entry refers.
• VLAN ID. Specifies the VLAN ID to which the entry refers.
Figure 4-22