239
GS752TP, GS728TP, and GS728TPP Gigabit Smart Switches
The initial value is blank. This information is not retained across a power cycle. The
maximum number of characters in a name is 160.
3. Optionally, configure the following settings:
• In the Count field, specify the number of pings to send.
The valid range is 1–15.
• In the Interval (secs) field, specify the number of seconds between pings sent.
The
valid range is 1–60.
• In the Size field, specify the size of the ping (ICMP) packet to send.
The valid range is
0–65507.
• The Results field displays the result after the switch sends a ping request to the
specified address.
4. Click APPL
Y to send the ping. The switch sends the number of pings specified in the Count
field, and the results are displayed in the Results field.
• If a reply to the ping is received, you see “Reply From IP/Host: icmp_seq = 0. time =
xx usec.
Tx = x, Rx = x Min/Max/Avg RTT = x/x/x msec.”
• If a reply to the ping is not received, you see “Reply From IP/Host: Destination
Unreachable.
Tx = x, Rx = 0 Min/Max/Avg RTT = 0/0/0 msec.”
Ping IPv6
Use the Ping IPv6 screen to send a ping request to a specified host name or IPv6 address.
This checks whether the switch can communicate with a particular IPv6 station. When you
click the APPLY button, the switch sends three pings, and the results are displayed.
To configure the settings and ping a host on the network:
1. Select Maintenance
Troubleshooting Ping IPv6.
The following screen displays: