Filter
Top Products
Switching Commands
100
ProSafe M4100 and M7100 Managed Switches
no storm-control multicast level
This command sets the multicast storm recovery threshold to the default value for all
interfaces and disables multicast storm recovery
.
Format no storm-control multicast level
Mode
storm-control multicast rate (Global)
Use this command to configure the multicast storm recovery threshold for all interfaces in
packets per second. If the mode is enabled, multicast storm recovery is active, and if the rate
of L2 broadcast traffic ingressing on an interface increases beyond the configured threshold,
the traffic is dropped. Therefore, the rate of multicast traffic is limited to the configured
threshold.
Default
Format storm-control multicast rate <0-14880000>
Mode
no storm-control broadcast rate
This command sets the broadcast storm recovery threshold to the default value for all
interfaces and disables broadcast storm recovery
.
Format no storm-control broadcast rate
Mode
storm-control unicast
This command enables unicast storm recovery mode for an interface. If the mode is enabled,
unicast storm recovery is active, and if the rate of unknown L2 unicast (destination lookup
failure) traffic ingressing on an interface increases beyond the configured threshold, the traffic
will be dropped. Therefore, the rate of unknown unicast traffic will be limited to the configured
threshold.
Default
Format storm-control unicast
Mode
Global Config
0
Global Config
Global Config
disabled
Interface Config